Hey guys!
Over two years in the past I designed my first romper! It was cute however…individuals weren’t actually into it. SO I went again to the drafting board and glued some key points to design an improved romper that I hope you’re keen on!
The Supershort™ Runsie
The straps
Romper 1.0 had non-adjustable straps, which I see now as a REAL drawback. So the straps at the moment are adjustable! Simple repair.
The interior panty
I fully swapped out the built-in panty for built-in shorts, which is wayyy extra comfy. Oh, and the interior pockets are anti-cameltoe (duh).
Pockets
These interior shorts I added? They’ve POCKETS!
The general form
The 1.0 shorts have been poofing and general, the entire romper simply wasn’t snatching the way in which I wished it to. I borrowed the sample from my viral Supershort, so the bottoms are tremendous stretchy and the hem is angled inward to provide you extra booty shaping.
To create the snatch impact, I added 2 mesh facet panels to attract the attention extra towards the middle.
Able to see?!
Earlier than you ask…
The commonest query after I publish a couple of one-piece outfit. Right here’s the way you pee.
You are taking the shoulders off, slide em down, you go, you wipe, and also you flush. Don’t overlook to scrub your fingers. With cleaning soap ideally.
👍
I’m 5’5” sporting the POPFLEX Supershort Runsie in sz XS! It is available in XXS to 3X and suits very true to measurement! Hope you want this one higher than romper 1.0!
